| NAK Type Z |
Metal O.D. with ground surface and rubber. |
| NAK Type G |
Corrugated O.D. for use where the housing material is subject to large thermal expansion. |
| NAK Type J |
The flange will allow easy installation or replacement. |
| NAK Type U |
Triple flat lip design for use in heavy dirt applications. |
| NAK Type P |
The flange will allow easy installation depth into the housing. |
| NAK Type BC/G |
Outside diameter sealing ability of rubber to counter rough or worn housings. |
| NAK Type X |
Pre-lubrication of the seal to combat initial dry running. |
| NAK Type H |
Case design adds structural rigidity particularly when there is a large radial seal width. |
| NAK Type E |
Metal case reinforcement of the lip flex section makes this series suitable for high pressure applications. |
| NAK Type N |
Short flex section makes this series suitable for high pressure applications depending on the shaft speed and runout. |
| NAK Type VA |
Grease retention seals with variations depending on the application. |
| NAK Type O |
The external series have the same characteristics as the internal series but are designed to seal a rotating housing. |
| NAK Type Q |
Lip flex section makes this series suitable for high pressure applications depending on the shaft speed and runout. |
| NAK Type A |
Short flex section makes this series suitable for high pressure applications. |
| NAK Type 4/9 |
Grease retention seals with variations depending on the application or installation conditions. |
| NAK Type AP Seals |
For use in heavy contaminated applications such as agricultural machinery, construction and mining equipment. |
